Android application
for operation control of
the USB-programmer
 
 
WizardProg for TL866 Android Application
 
 
Home  |  Download  |  Contacts & Order
RU   EN   CN
 
   
 
WizardProg Mobile trademark

WizardProg Expert trademark

The mobile application software "WizardProg Mobile" (or its enhanced, paid version "WizardProg Expert") is designed to programmatically control the operation of the portable universal TL866 USB programmer, as well as fully compatible models. The system, which includes a programmer and a mobile device with an application version installed on it (hereinafter — "WizardProg for TL866" application / system), is used to program a wide range of E(E)PROM chips, microcontroller's internal EEPROM, testing SRAM and logic chips.

The application allows you to achieve a new level of mobility and efficiency when using the programmer TL866, which is used widely to repair and adjustment:

  • automotive computers, computer-unit and radio;
  • personal computers;
  • any other modern electronic equipment.

The "WizardProg for TL866" system is used by service technicians of electronics, amateur radio operators and developers of modern electronic devices for the purpose of:

  • repair and restore the microelectronic device and firmware;
  • promptly update the firmware of microelectronic devices;
  • assist in the embedded electronics construction and setting up the microcontroller units;
  • replicate numerous useful designs using advanced electronic components.

Main characteristics and features of the "WizardProg for TL866" microelectronic programming system are:

  • Fast and reliable programming, in most cases with significantly better speed than the similar systems.
  • The programmer's low power consumption when powered by USB (OTG)-cable from the mobile device battery. Very compact size (10 × 6 × 2.5 cm).
  • ZIF40 contact panel with a 4-level protection of each contact from over-current and over-voltage, which increases fault tolerance of hardware and software in emergency situations.
  • Support for a wide range of integrated circuits (ICs): the memory of a large capacity up to 128Mbit (EPROM 26/27/37, FLASH 28 / 29 / 39 / 49 / Intel82 / ST M50 / TC58, EEPROM 24C / 85C / 25 / 26 / 45 / 95 / 93C / ST M35080), microcontrollers PIC, MCS-51 (Atmel / Intel / Philips-NXP), AVR (ATMEGA / ATtiny / AT90XXX), SST (SST89E, F, Cxx / SST89Vxx), SyncMOS (SM89 / SM79 / SM59 / SM39), Winbond (W78E5xx), PLD chips, GAL.
    The latest chiplists are: "WizardProg Mobile" & "WizardProg Expert"

TL866 programmer does not need an external power supply and it operates using the power sources of a tablet or mobile phone which is connected to via USB interface. Physical linking to a mobile device is provided with a USB cable fully supporting OTG (On-The-Go) protocol. Currently "WizardProg Mobile" application is completely autonomous in operation, does not need a permanent connection to the Internet, allowing you to use it even without access to communication networks. The "WizardProg Expert" application, in turn, requires access to the Internet (at least periodically) to confirm operating authorization, as a paid form of distribution requires.

Most of the supported devices in DIP packages are programmed without additional adapters. The exception are the devices with a 1.8-volt programming voltage, whose adapters for connection can be ordered or made independantly, according to the published scheme.

There are two modifications of the programmer TL866: TL866A - with supports in-circuit (ICSP) programming and TL866CS - without ICSP. The "WizardProg for TL866" application supports both modifications.

Attention!
The modern version of the TL866II Plus programmer currently is not supported by the "WizardProg for TL866" system!

WizardProg for TL866 performance for some popular ICs

Device Type Model Capacity Erase, sec Read, sec Write, sec Total, sec Notes
27Cxxx 27C512 512Kbit - 2 20.8 22.8 28pin
EE 27Cxxx W27E257 256Kbit 0.1 1 10.4 11.5
SST27SF512 512Kbit 0.1 1.4 20 21.5
Flash EEPROM AM29F040 4Mbit 7.9 9.2 26 43.1 32pin
AT49F002 2Mbit 1.2 3.6 16.4 21.2
AM29F200 2Mbit 3.7 2.0 8.6 14.3 48pin
AM29LV160DB 16Mbit 27 16 50 83
TE28F320C3B 32Mbit 29 32 79 130
AT48BV8192A 8Mbit 5 8 28 41
Serial EEPROM 24C02 2048bit - 0.1 0.3 0.4 8-16pin
AT24C512 512Kbit - 8.4 13.5 21.9
25080 8192bit - 0.01 0.1 0.1
25LC1024 1Mbit 0.2 1.5 3.9 4.6
EN25T80 8Mbit 8.4 12 18 38.4
MX25L8005 8Mbit 5.8 12 17 34.8
MX25L6405 64Mbit 42 98 166 302
95320 32Kbit - 0.1 0.5 0.6
93C46 1024bit - - - 0.1
93CS56 2048bit 0.1 0.1 0.4 0.6
MCU ATMEGA162V 16K + 512 0.1 0.6 + 0.1 2.5 + 0.4 3.7 code + data
ATTINY13 1K + 64 0.02 0.1 + 0.01 0.7 + 0.04 0.9
PIC12F629 2K + 128 0.1 0.1 + 0.1 2.2 + 0.3 2.8
PIC18F4550 32K + 256 0.5 3.7 + 0.3 5.6 + 1.2 11.3

 
 
 
Home  |   Download  |   Contacts & Order
© 2007-2023  WizardProg
 
     
23.07.2023 15:32